If you have some kind of insight as to how to deal with the mobile home axles on your trailer then it will be beneficial to learn about changing the mobile home axle parts. There is no doubt that it will be very difficult to swap out the whole axle as this will blow away your budget. There is a more cost effective solution to this. The process shown here in changing the mobile home axle parts involves converting the hubs into a 6 lug pattern. You will however have to note that the results may vary because the mobile home axles are not all the same.

In order to change the mobile home axle parts, you will have to first determine which of the parts have to replace the hubs. Indeed the best method of doing this is to take one of the old hubs because there are a number of varying kinds of spindles or bearings. You could easily end up with 6 lug hubs, outer and dinner bearings which come along with fresh rear seals and also dust covers. Moreover, it is possible to end up with 24 new lug nuts. After this you will have to grease the bearings, tap the rear seal and then take out the wheel and old hubs. This could easily be done by using a screwdriver and a hammer to take out the dust cap. This will grant you access to the cotter pin and the spindle nut.

When you take out the cotter pin, unscrew the nut which will lead to the whole wheel assembly sliding off. This will then prepare the way to install the fresh hub. Some of the mobile home axle parts come with breaks which may vary things for you. Put the small bearing in and use the spindle nut again from the older hub after sliding the new hub. Like all other axles, you have to remember to utilize the bearing grease on the fresh bearings of the wheel. Make sure you tighten the nut. Also bend the cotter pin and tap on the dust cover after inserting a new one.

After all this you will realize that not only is your new setup looking better but also it will be easy to maintain and change when required. Also changing the parts will make it lighter than the older one.